Clutch damage will affect our normal driving. If your car has the following conditions, you need to pay attention. Your clutch may be damaged, and you need to check and repair it and clutch cable replacement in time.
The clutch becomes higher, and the clutch can be put into gear after stepping on the bottom. Originally, the car could be driven by lifting the foot by one centimeter, but now it was lifted by two centimeters. This means that the clutch plate is worn thin and the auto clutch cable is not connected well. The clutch plate must be lifted up to engage. When the engine accelerates during driving, the speed of the car cannot be increased, the power of the engine cannot be completely transmitted to the transmission part, and the driving is weak.
When the clutch fails and the friction capacity of the driven part decreases, the power of the car decreases. In the absence of any abnormality in the engine, whether starting or climbing, the car feels sluggish, the engine speed is high, or the power is insufficient, indicating that the clutch is prone to premature slippage and the car clutch wire connection is unstable. Or the clutch is in a semi-linked state during starting for a long time, and the engine cannot output a large torque to the transmission system through the clutch, resulting in the vehicle transmission system being unable to obtain a large driving force, and in severe cases, the vehicle may not be able to start.
When driving at high speed, the reaction of refueling and overtaking is slow, and the throttle is increased, and it feels like the engine is idling, the car is not accelerating, and the clutch is slipping. In other words, the engine can run to 80km/h at 1800 rpm, but now it needs 2000 rpm. In addition, when the load is increased, the clutch disc is prone to overheating and the auto clutch cable is worn out and slips more obviously. In severe cases, it will emit a burning smell, smoke, or even burn out the clutch bearing.
Another situation is that the clutch surface is not flat and needs to clutch cable replacement, whether it is thick or thin. The phenomenon is that the vehicle shakes a lot when starting, and when it is half-clutched, it is because the clutch surface is uneven. This situation is mostly due to the quality of the clutch disc. Or the engine does not stall when the parking brake is tightened and the car is started in low gear.
In general, fuel consumption suddenly increased. There are many reasons for the increase in fuel consumption. When one of the above four conditions occurs, and accompanied by an increase in fuel consumption, it can be basically determined that the clutch system of the car is faulty, and the reason is not the damage of the auto clutch cable or the clutch disc. The reason, so we need to overhaul the clutch cable repair in time.
The above is the driving performance of the damaged clutch introduced by car clutch wire supplier—Huafeng. The car clutch wire and auto clutch cable we produce are of trustworthy quality, long service life, and high price ratio!
Recommended reading:
The performance of a broken car clutch
How to adjust the clutch cable
The principle of the car's brake system
