In order not to make the wires messy, to facilitate the installation of Automobile Control Cables and avoid wire damage, it is generally necessary to wrap the wires on the vehicle into a wire harness, which is called a cable. The method of wrapping the cable: After selecting the wire, cut it off according to the length of the wire used at each connection part. If there is no size data, you can first remove the old cable, measure the length of each part of the wire, or directly measure the size on the car, and then cut it off.

Then, gather the wires that should be bundled together, according to the original form of the cable, leave the branch of the branch line and the outcrop of the specified length, and wrap it with tape at each branch and branch to avoid messy during the binding. Loose. After shaping according to the above arrangement, use white gauze tape or plastic tape to wrap it up by half-folding. In this way, the wire harness will be covered with two layers of gauze tape, which is relatively firm. When bandaging, pull the cloth strap tightly and connect the head to prevent it from loosening. Finally, apply foreign dry paint or asphalt paint on the gauze tape, and dry or dry it to increase the strength and insulation performance of the cable.