Motorcycle control cable's wire conduit selection

Date: 2021.09.16 Viewed:

Wire conduit for motorcycles is a very important material for motorcycles we drive, and its quality is directly related to the safety of our driving. There are many factors to consider comprehensively when choosing a control cable. Huafeng is here to share some small experiences of motorycycle control cables, hoping to help everyone.

Breather pipes are generally pulled out of the cylinder head, this wire conduit is generally slightly thicker than the fuel pipe and is mostly made of synthetic rubber. Its function is to give the crankcase of a 4-stroke engine an external ventilation pipe. As a result, if the internal volume of the crankcase changes due to the movement of the piston, Since the vent pipe can swallow air to the outside, the air pressure in the crankcase will not change too much.

Gearbox breather pipe: There is no throughput effect on a running 4-stroke engine and it is usually exported from the top of the gearbox (not on a scooter 2-stroke engine; it is thin enough to partially prevent dust ingress. A plastic pipe is sufficient. Its function is to provide the engine gearbox with an externally ventilated pipeline to squeeze out and permeate the lubricating oil as the gas in the engine gearbox expands and contracts due to heat. There is no internal air pressure. For vehicles that will not be used for a long period of time, it is recommended to tie the nozzles of wire conduit tightly with a plastic bag to avoid condensation due to the breathing of the gearbox. Temperature difference between day and night.

The entire line of the motorcycle is connected to the electrical parts of the entire vehicle centering on the main cable harness, and the connections of each part are connected via plug-in parts, which is intended for easy replacement. Ensures reliable parts and overall connections. The placement of these connection points is scientifically designed. It must be hidden, waterproof and beautiful, while ensuring convenience and speed.

The electrical system of a two-wheeled vehicle is very simple. There are several major systems: ignition and charging systems, signaling systems, lighting and starting systems. Insulating tape is used in the ignition system. Using insulating tape in Magneto's internal circuitry can cause the motorcycle to malfunction or start, and a short circuit can burn electrical components.

Signal systems, such as the use of insulating tape in densely populated areas behind the headlights, fail in a relatively short period of time, causing the ends of the wires to loosen or fall off (caused by the wires in them). The location is non-stop action with the rotation of the handlebar), its moisture-proof and waterproof performance is significantly reduced, causing terminal oxidation and corrosion, increased line contact resistance, or direct short circuit with iron, producing a signal. The lamp behaves abnormally.

The power system has two relays, positive or negative, and the outputs and inputs are positive and negative. The starting circuit and charging circuit are all high current channels. A short circuit can burn the electrical lock and cable harness, especially for high power batteries and motorcycles where the fuse cannot be used properly.

From a practical operational point of view, these connectors are scientific, but not all are convenient. Often it is necessary to remove some of the housing and accessories to expose them completely. For example, after replacing the turn signal, most vehicles will need to disassemble the seat to disassemble the turn signal connector.

As a professional motorcycle control cable exporter, Huafeng offers a variety of motorcycle control cables that cover the popular motorcycle brands and models on the market. Welcome to inquiries about motorcycle control cables.