The clutch is a component directly connected with the engine in the automobile transmission system. It is responsible for the cutting and combination of the power and the transmission system, so it can ensure the smooth start of the car when starting, and also ensure the smoothness of the gear shift, and also prevent the transmission system overload.

The method of adjusting the clutch up and down is:

1. Carry out a gear test drive to find the appropriate clutch position;

2. Adjust and loosen the nut on the clutch;

3. After adjusting the loosening, twist the rod;

4. Test drive after lowering the clutch.

The function of the clutch is to:

1. Ensure that the car starts smoothly;

2. During the driving process of the car, avoid the force transmission gear meshed in the gearbox not being removed due to the load;

3. Prevent the transmission system from overloading;

4. Reduce torsional shock.

The clutch is located in the flywheel housing between the engine and the gearbox. The clutch assembly is fixed on the rear plane of the flywheel with screws. The output shaft of the clutch is the input shaft of the gearbox. During the driving of the car, the driver can depress or release the clutch pedal as required to temporarily separate and gradually engage the engine and the transmission to cut off or transmit the power input from the engine to the transmission.

The maintenance method used by the clutch is:

1. Clean before installation, remove anti-rust grease and sundries;

2. When the wet electromagnetic clutch works, lubricating oil needs to be added between the friction plates;

3. When installing coaxially, the axial direction needs to be fixed to avoid axial movement between the active part and the driven part;

4. When installing in separate shafts, the coaxiality between the active part and the driven part shaft should not be greater than 0.1mm.

How often to change the clutch:

There is no time limit, and the clutch cable can be used as long as it is not damaged. The situations and functions of the clutch line that need to be replaced are as follows:

When the clutch line needs to be replaced:

When it is found that the clutch line is stepped down and the friction is severe, or the return position is abnormal, it can be replaced. Generally, water ingress causes rust between the steel wire and the protective cover, which leads to poor return of the cable.

Huafeng is a professional brake cable supplier in China. We produce universal brake cable, parking brake cable and automobile control cables for various models. If you are interested, you can contact us and we can send you samples!