What is the role of a car's clutch? Next, Huafeng, the manufacturer of peugeot 206 clutch cable, will give you a brief introduction.

The clutch is the component that disconnects and connects the power system in the automobile transmission system. The auto clutch cable is the steel wire that controls the clutch, usually covered by a steel wire sleeve. As one of the key components of the automobile, the automobile clutch can correctly control the transmission and power system. The automobile clutch can start the vehicle smoothly and complete the normal gear shift at the same time. The car you drive. If the gear is too heavy or the gear is not suitable, the clutch can also give corresponding prompts. When driving a car, the driver can step on and release the clutch pedal as needed to temporarily separate the engine and the transmission and gradually engage them, turn off the power input from the engine or transmit it to the transmission. Clutch is a common part of mechanical transmission, which can be disconnected or connected to the transmission system at any time.

The clutch is a component that guarantees a smooth start and smooth shifting of the car. The clutch is located in the flywheel housing between the engine and the gearbox. The clutch assembly and auto clutch cable are fixed on the back of the flywheel with screws. The output shaft of the clutch is the input shaft of the gearbox. When the car is running, the driver steps on the clutch pedal as needed to temporarily separate the engine and the gearbox, and gradually engage to shut down or transmit the power input from the engine to the gearbox. The clutch works when the vehicle starts and shifts gears. At this time, there is a speed difference between the first shaft and the second shaft of the gearbox. After the engine power needs to be cut off from the first shaft, the synchronizer keeps the engine speed synchronized with the second shaft. After the gears are engaged, the first shaft is connected with the engine power through the clutch, so that the power continues to be transmitted.

In the clutch assembly, the car clutch cable and other components are fixed on the back of the flywheel housing with screws. The output shaft of the clutch is the input shaft of the gearbox. When driving a car, the driver can step on the clutch pedal as needed to temporarily disengage and gradually engage the engine and gearbox, blocking the power input of the engine or transmitting it to the transmission. Clutch is a common part of mechanical transmission. With car clutch cable, it can be disconnected or connected to the transmission system at any time. The basic requirements are as follows: smooth joining, fast and thorough separation; convenient adjustment and maintenance; small size, low quality, good wear resistance, sufficient heat dissipation capacity, convenient operation and labor-saving. Commonly used friction types are divided into two types: jaw type and friction type. The peugeot 206 clutch cable produced by Huafeng can be fully adapted to the clutch system.

Recommended reading:

What should I do if the manual clutch line is broken?

Introduction to the principle of motorcycle clutch

The principle of the car's brake system